Q-Loc Lighting Connector Land Supply Canada Landscape Lighting Land Supply Canada 29.39
Q-Loc Lighting Connector Land Supply Canada Landscape Lighting Land Supply Canada 29.39
Q-Loc Lighting Connector Land Supply Canada Landscape Lighting Land Supply Canada 29.39
Q-Loc Lighting Connector Land Supply Canada Landscape Lighting Land Supply Canada 29.39

Q-Loc Lighting Connector

$29.39
/
Shipping calculated at checkout.

Perfect for Low Voltage Lighting – Great for Irrigation Connections

NewLite's Q-Loc Lighting Connector was designed specifically to make your lighting jobs cleaner and easier to install. It's innovative locking bolt creates a quick connection, and allows for safe movement of the fixtures during final placement. Keeping in mind that every connection needs two connectors, Q-Loc designed their connectors to snap together allowing for a cleaning looking installation. The earth toned color and the grouping of the connectors allows the Q-Loc to be easily hidden in the landscape.

Product Details

  • The innovative locking bolt creates a quick connection while allowing for safe movement of the fixtures during final placement.
  • Patented distribution of silicone gel makes sure you have a water-tight seal every time.
  • Keeping in mind that every connection need two connectors; we designed our connectors to snap together allowing for a cleaner looking installation
  • IMPORTANT: Turn off all power before installing or removing any connectors. For use in damp, wet, rain-tight, and short term submersbible locations. Not to be used in continuous submission applications.
  • Wire Range: Min #20 / Max #10
  • Temperature Rating: 105 degrees C (221 degrees F)
  • Sealant Temperature: -45 F to 400 F

Model #:

  • 20 Pack: QL/NLQ-LOC
  • 50 Pack: QL/NLQ-LOC50

STEP ONE

Open Top Locking Bolt

STEP TWO

 Insert Striped Wires

Turn the top locking bolt counter clockwise until there is a clear pathway through the front opening of the connector. No need to fully remove.  

Strip wires 3/4" - 1", Fan and Pre-Twist ends then insert into the connector as far as the wire will travel. 

STEP THREE

Hand Tighten Locking Bolt

STEP FOUR

For A Clean Installation

 

No need to over tighten. The locking bolt will press against the wire jacket and not the bare capper ends; giving it a better hold and secure connection

Press the male end of one connector into the female end of another connector. This will group your connectors together, and give a clean looking installation.